Manhole step of polypropylene orange inside part of
Manhole step of polypropylene 330mm
RANGE / MARK ®
CHOICE OF PRODUCT
Step iron and guide
MARKET / APPLICATION
- Material and coating: corrugated steel core of 12mm covered with Copolymer Polypropylene of high impact resistance.
- Manhole steps have patterned surface to avoid falls.
- In accordance with EN 13101: - Test of load: deflection ≤ 10mm on a vertical load of 2 kN, with permanent deflection ≤ 2mm - deflection ≤ 50mm on 4 kN, class I - Unfix: minimal effort of 5 kN - Impact: mass 20 kg drop shot to fall down from a height of 1 m - Twisting: ≤ 5mm in the whole extension of the front bar
Once concrete is hardened two 25 mm diameter holes are drilled to install the step. There should be a distance of 330/300mm between the center points of the two holes and a 85/105mm depth (it depends upon the model).
The manhole step should be tapped on each end alternately until fully inserted to a depth of 80/100mm.
It is essential to check that the holes are drilled accurately. Otherwise there will be necessary to fill in with mortar or filler.