Sheet and Coil
HOT ROLLED COIL AND SHEET STEEL
Hot rolled steel is rolled on a continuous strip mill, generally above 1600°F (870°C), to the desired thickness. The steel is supplied with either a standard “black” finish, or pickled and oiled, in slit coil or sheet form.
Quality Relevant Specifications Characteristics
Carbon – Manganese A1011 CS Suitable for simple bending and moderate forming, mechanical properties not specified.
Commercial Steel Type A, B, C
Drawing Steel A1011 DS Non Aging Steel, eliminates possible fluting and stretcher strains during forming.
Special Killed Type A, B
Structural Steel A1011 SS (various strength levels) minimum yield strength ranging from 30,000 PSI to 55,000 PSI Specified whenever guaranteed mechanical properties are required.
CSA W grades are now available in selected sheet sizes (per CSA G 40.21).
THEORETICAL WEIGHT PER SQUARE FOOT HOT ROLLED (.1793–.060)
| Gauge | Nominal Thickness In Inches | Estimated Weight Per Square Foot |
|---|---|---|
| 7 | 0.1793 | 7.5 |
| 8 | 0.1644 | 6.875 |
| 9 | 0.1495 | 6.25 |
| 10 | 0.1344 | 5.625 |
| 11 | 0.1196 | 5 |
| 12 | 0.1046 | 4.375 |
| 13 | 0.0897 | 3.75 |
| 14 | 0.0747 | 3.125 |
| 16 | 0.0598 | 2.5 |
| 18 | 0.0478 | 2 |
| 20 | 0.0359 | 1.5 |
| 22 | 0.0299 | 1.25 |
| 24 | 0.0239 | 1 |
| 26 | 0.0179 | 0.75 |
| 28 | 0.0149 | 0.625 |
| – | – | – |
For material heavier than 7 gauge (.1793) see plate section.
Products Include:
Locations offering this product: