How to Fix a Loose or Rocking Toilet
Rocking is for concerts and chairs—not toilets. If your toilet is wobbly or loose but not leaking, this quick fix might be just what you need. Toilets usually rock because they are not resting flush against the floor. Underneath the toilet base is a round toilet flange that connects the toilet to the drain pipe. If the flange is a little higher than the surrounding flooring, the toilet becomes raised slightly in the center, allowing it to rock to either side.
This problem can develop over time, such as when the wax seal becomes faulty or when a surrounding floor settles a little. Fortunately, there is an easy fix.
Watch Now: How to Fix a Rocking Toilet
What You'll Need
Equipment / Tools
- Utility knife
- Plastic shims
- Tub and tile caulk (color-matched to your toilet and flooring)
- Paper towels or rag
Check the Bolts First
Sometimes a rocking toilet can be fixed by tightening the two flange bolts, or closet bolts, at the base of the toilet. Do this carefully. Tightening the bolts too much can crack the brittle porcelain of the toilet, for which there is no repair.
Check the flange bolt at each side of the toilet, using a pair of pliers or a small wrench. If a bolt is loose, tighten it slowly just until it is snug. Check the other bolt to make sure it is equally snug, then test the toilet for rocking. If it still rocks, proceed with shimming the base.
Look for Leaks
Confirm that your toilet is not leaking. Check carefully for water around the base of the toilet. If water is not present, you can proceed with the repair. But if there are signs of leaking around the base, it likely means that the wax ring sealing the toilet horn to the toilet flange has become old and compressed. In this case, you must remove the toilet and replace the wax ring.
Locate the Gaps
Examine the base of the toilet, and identify any gaps between the toilet and the floor. It may help to rock the toilet from side to side. Even a small space can be the source of the problem. If the gaps are too small to see, try sliding a shim under the base to see how far it goes in.
Insert the Shims
Level and steady the toilet by inserting shims into any gaps you've identified. You may have to try them in a few different positions to properly level the toilet. As you work, check the toilet for stability by sitting on the seat and rocking in all directions. Repeat until the toilet doesn't move in any direction.
Trim the Shims
Trim the shims close to the base of the toilet, as needed, using a sharp utility knife. Be careful not to cut into the flooring.
Caulk Around the Base
Apply a thin, even bead of caulk around the base of the toilet to cover the gap along the floor and hide the shims. If necessary, smooth the caulk with your finger, wiping your finger clean frequently with a paper towel or a rag.
Let the Caulk Dry
Allow the caulk to cure as directed before using the toilet. Once it dries fully, your toilet should be as good as new.
If the Toilet Won't Stop Rocking
If tightening the flange bolts or shimming the toilet base doesn't stop your toilet from rocking, there might be more significant problems down below. The flange bolts that secure the toilet base are themselves held by a metal or plastic ring at the top of the toilet flange. The ring can corrode or break, loosening its grip on the bolts.
If the rocking comes back after a while, or if the bolts loosen up and won't retighten, a damaged flange is likely the cause. The solution is to remove the toilet and either replace the old flange or repair it with a flange repair kit.